alproof
drum_vacrlr_le_pos
dvrlr
Trendsetter_400/800_Proofing
The drum position, in encoder ticks, where the surface of the LE registration
pins line up with the contact point of the vacuum roller, were the two are
physically able to contact.
This is used as the starting point for all drum positioning where the vacuum
roller is involved; i.e. all proofing load & unload drum positions are
calculated starting with this parameter.
This parameter MUST be calibrated during machine integration, if the encoder disk
has been replaced, or if the NVS parameters have been re-initialized and the
original value has not been restored for some reason.
int32
20797
0 to 36,000 (drum encoder ticks)
See http://intranet.creo.com/support/docs/Spectrum_Media_Alignment.pdf for more
information.
cal